Delfi-n3Xt Update: Some Bad News

Delfi-n3Xt Satellite

Delfi-n3Xt Satellite

Delfi Nanosatellite Program Manager, Jasper Bouwmeester PC4JB, has announced the results of the testing carried out on the Delfi-n3Xt CubeSat 435/145 MHz linear transponder.

Dear radio amateurs,

Unfortunately, we have not heard anything from Delfi-n3Xt since Thursday 20/02 after our transponder test. During the transponder test we could hear our side beacon at 145.870 MHz and we were still able to switch back to normal transmission an back to transponder again (and also received the beacon the second time). Nothing seemed to be wrong, except for the transponder itself not properly working. The satellite was supposed to return to nominal operations in the next orbit.

We think that a hardware failure occurred either at the second half of the transponder orbit or during the mode switch. Since Friday we have made many attempts to revive the satellite. Since we have an independent radio, there was (and still is some) hope to get the satellite back in transmission. There are however a few points were common mode failures could occur: the phasing circuitry which connects both transmitters and an I2C buffer at the main bus side. We do however still have some hope that only one radio has failed and that we might still be able to command the satellite to use the other. Since all trivial command schemes did not work, next week we will only focus on a specific test to turn the transmitter on for a brief moment. During the weekend we saw some narrow band signal at 10 kHz below 145.870 MHz (+/- Doppler), which might potentially be related to the local oscillator. If we can reconstruct this a few times and clearly correlate this to Delfi-n3Xt (we do have a lot of intermitting noises sources in the neighbourhood) we at least know the OBC and one radio is still working and we can commence to next steps.

We appreciate everyone’s help to listen to Delfi-n3Xt to see if there is still some signal left. I think the best changes (besides Delft passes in which we try to command) are when the satellite comes just out of eclipse and is supposed to startup one of the transmitters. Please note that it has become very crowded with CubeSats lately, so any signals which are off in frequency (except for the -10 kHz tone), have a very different bandwidth and/or Doppler shift are very likely to be other satellites in the neighbourhood. Today we had for instance Delfi-C3 almost perfectly aligned sending at the same frequency. Delfi-n3Xt will only transmit at about 145.870 MHz.

If the situation changes, I will provide you with an update.

Best regards,

Jasper, PC4JB

IARU coordinated Delfi-n3Xt frequencies
• 145.870 MHz Telemetry
• 145.930 MHz Telemetry
• 2405.00 MHz High speed data
• Inverting SSB/CW transponder
– 435.530-435.570 MHz uplink LSB
– 145.880-145.920 MHz downlink USB

Telemetry reception http://www.delfispace.nl/operations/delfi-n3xt-telemetry-reception

Delfi-n3Xt http://www.delfispace.nl/operations/radio-amateurs

Dnepr Yasny launch https://amsat-uk.org/satellites/dnepr-november-2013/

Results of first Delfi-n3Xt transponder test
https://amsat-uk.org/2014/02/20/results-of-first-delfi-n3xt-transponder-test/

Delfi-n3Xt transponder to be tested
https://amsat-uk.org/2014/02/17/delfi-n3xt-transponder-to-be-tested/